The signal conditioner is used to convert potentiometric input signals
into standardized voltage or current signals, and supplies the position
sensors with a constant, highly stable voltage. The MUP400 has a high
sample rate of up to 5 kHz. Users can select either 0 to 10V or 4 to
20mA outputs by setting a DIP switch. Auto-calibration is achieved by
pressing two buttons on the front of the device to set offset as well
as span. The span can be limited to 80% of the total input range. The
MUP400 also has low temperature drift of 25 ppm/K.
Companies in this article
.jkBzux4bVh.jpg?crop=focalpoint&fit=crop&fp-x=0.5&fp-y=0.5&h=167&w=250&auto=format%2Ccompress&q=70)
