Nord Drivesystems: Industrial gearboxes

Gearboxs are designed to handle the most demanding bulk material handling applications, cement and steel processing, wastewater management and more.

NORD recently added two new sizes to the MAXXDRIVE line; the 133,000 & 177,000 in-lb nominal torque units.

The entire MAXXDRIVE line is modular and can be configured with a wide array of application-specific options including auxiliary drives, brakes, torque arms, backstops, swing bases, and even extruder flanges. The single-piece UNICASE housing provides mounting options on all six sides. All bearings and seals are contained within a single casting, with none of the housing splits and bolt-on carriers that plague competitive systems. Use of a one-piece UNICASE housing also provides high rigidity, more accurate shaft alignment and higher load-bearing capacity. The result is quiet operation, exceptional component life, and high reliability.

Gear ratios across the line are available in fine increments from 5.54:1 up to 30,000:1, with two, three, or four gear stages as well as an auxiliary reduction gear stage if needed. A number of sealing options are available, as well as a full complement of input and output shaft options. The units are available as either parallel shaft, or right-angle design using a spiral bevel input. Remote monitoring and temperature management solutions are also available.