Download this free, 130-page Package Development Playbook jam-packed with strategies for success, best practices, and pitfalls to avoid.
Learn more »»
Article |

Reaching Peak efficiency (sidebar)

Banding together
FILED IN:  Package Type  > Tubes
There are a trio of shrink banders on each of Peak Foods' two lines.This photo shows flights that encircle the bowls to ensure positive control and a centered shrink band.

The other improvements at Peak Foods are upgrades to the tamper-evident shrink-banding operations. Peak’s single four-headed bander was replaced by two three-head tamper-band applicators from Axon Corp. Peak’s production flow is split equally to each three-head bander. One 7’-long heat tunnel was retained from the prior setup and a new tunnel has been added.

Peak general manager Steve Vogel says that each unit can handle half of the production flow with as few as two heads so the extra head on each provides production “headroom” so to speak. The units automatically switch flow to the third head if one of the two heads acts up according to Vogel. “This means that we don’t disrupt our production flow” he says. “It’s worked beautifully.”

Vogel is especially appreciative of Axon’s new design. Previously the bowls were transported on a tabletop conveyor between flights and a siderail. The band was dispensed over the bowl and rested atop the rail and the moving flights. The bands were “tacked” to the bowl with spot heaters before moving from the flighted section to the shrink tunnel. Vogel explains that it wasn’t uncommon for the band to become lopsided as the bowl conveyed inside the heat tunnel.

Related Sponsored Content

Secured flight

The new machine design eliminates improper positioning of the shrink bands since the bowls are transported in circular stainless-steel flights. A front half-circle flight and a rear-half-circle flight come together to encircle each bowl. Cut from a folded tube in web form the 1¼’’-wide tamper-evident band is dispensed around the bowl and rests atop this flight.

“The band is supported 360 degrees atop the flight from the point it is applied and stays that way through the shrink tunnel” says Vogel. “There’s no place for the band to go when the hot air heat hits it except straight in toward the center of the bowl. It does a better banding job than before with very nice alignment. Not only are the aesthetics better there are much fewer rejects than before.”


Production manager Debbie Friend says that reject rates of improperly banded bowls had been running from 5% to 7%. The redesigned bowl transport system has lowered rejects to just under 0.5%. Which is why Peak personnel have been bowled over by the banding improvements.

See the story that goes with this sidebar: Reaching Peak efficiency

E-Book Special Report
Total Cost of Ownership
Sign up to receive timely updates from our editors and download this E-Book Special Report to learn how to calculate the true Total Cost of Ownership (TCO) of your packaging machinery.


Don't miss intelligence crucial to your job and business!
Click on any newsletter to view a sample. Enter your email address below to sign up!
Each newsletter ranges in frequency from once per month to a few times per month at most.